What this simulation shows
Build a circuit on the grid, and the simulation works out the current through every part and the potential difference (p.d.) across it. Lamps glow more brightly when they transfer more power, LEDs light up when they conduct, and moving dots show the current. Choose whether the dots show conventional current, from positive to negative, or the electrons, which flow the opposite way.
How to build a circuit
Pick a part from the toolbar, then tap a gap between two dots to place it. Every part, including a plain wire, joins two neighbouring dots. A circuit only works if there is a complete loop from one terminal of the battery back to the other. Choose Select and tap a part to see its readings, change its value or turn it round. On a keyboard, focus the circuit and use the arrow keys, O to turn the cursor and Enter to place.
Current and potential difference
Current is the rate of flow of charge, measured in amperes with an ammeter placed in series. Potential difference is the energy transferred per unit of charge, measured in volts with a voltmeter placed across a component. The simulation's meters behave like good real ones: the ammeter has almost no resistance and the voltmeter has a very high resistance.
The current through a component depends on the p.d. across it and its resistance:
Series and parallel
In a series circuit there is one loop. The current is the same everywhere, and the p.d.s across the components add up to the supply p.d. In a parallel circuit each branch connects across the same two points. Every branch has the full p.d., and the branch currents add up to the current from the supply. Use the starting circuits to check each rule with the meters.
Components to explore
- Filament lamp: its resistance rises as it gets hotter, so its I–V graph curves.
- Diode and LED: current flows one way only, once the p.d. is above a small threshold. An LED needs a resistor in series to limit the current.
- LDR: resistance falls as the light gets brighter.
- Thermistor: resistance falls as the temperature rises.
- Fuse: breaks the circuit if the current goes above its rating.
Short circuits
If you join a battery's terminals with just a wire, a huge current flows. The simulation warns you when this happens. Real cells have a small internal resistance, which the simulation includes, so you may see readings very slightly below the ideal values.
Symbols in your course
The simulation uses the symbols in UK and international syllabuses. US courses often draw a resistor as a zigzag instead of a rectangle; the physics is the same.